PS1504 1.55kva tower Mil 901,167 approved
800-209-5556
Drawing and foundation drawings.
Block_Diagrams_with_Bypass_1503.pdf
1050 Watt output, 1500VA
Shipboard UPS
230V European model available – PS1504i tower
Next Generation UPS with higher efficiency and green mode
Hot swap batteries with hitemp60d c and long life 10-12 year life two hx80 batteries 60 d Centigrade.
LCD easy to
understand written text readout
in many languages on front panel for
status
UPS wired for Delta power shipboard power---shipboard ready
Dual pole circuit breaker -No fuses to try to find while at sea
200g circuit breaker available as option- same as the 1503 the sensata hi-g breaker
Auto Boost and Trim voltage trim without using Inverter
Smart UPS tests itself and batteries periodically running Powerchure software
Auto restart after a full run upon AC MAINS restoration
Cold Start capable- Use this as a portable AC power source
Field replaceable batteries either the psrbc7 or psrbc7h
Output Power Capacity 1050 Watts / 1500 VA
Nominal Output Voltage 120V; 230V i MODEL
Output Voltage Distortion Less than 5% at full load – 98% efficient @ Full load
Crest Factor up to 5: 1 Waveform Type Full Sine wave
Transfer Time 2-4 ms (less than ¼ of cycle) Most electrical equipment is designed to survive a 200ms hit. Your equipment will not notice this transfer.
Used on the Navy ships with louvered stainless steel with hot swap batteries- 1503 cover is stainless steel and with drip louvres
Batteries including out premium bateeries that have a 10-12 year life and work at 60degree C
Manual maintenance bypss swith optional for certain clients that want manual bypass
rs232interface not compatible with 1503 software except powerchute
|
(8) NEMA 5-15R mil connectors 2 mil 3102xxx |
|
|
8) IEC 320 C13 |
|
Input
Nominal Input Voltage 120V; Input voltage range for main operations 82 - 144V
Input Frequency 50/60 Hz +/- 3 Hz (auto sensing)
|
Input Connections NEMA L5-15P Cord Length 6 feet (1.83 meters) mil connectors input and output or mil 3102xxx |
||||||
|
Euro i
MODEL Input Nominal Input Voltage 230V; Input voltage range for main operations 160 - 286V IEC 320 C14- Cord supplied |
||||||
Battery Type Maintenance-free sealed Lead-Acid battery with suspended electrolyte: leak proof
Typical recharge time 3 hour(s)
Replacement Battery PSRBC7 (high temperature long life batteries available for this unit PSrbc7h)
Typical life expectancy @75°F= 3-5 years
Premium battery life expectancy @75°F= 8-12years
Typical Backup Time at Half Load 24 minutes (490 Watts)
Typical Backup Time at Full Load 6.7 minutes (980 Watts)
Typical Backup Time at 425 Watts= 30 minutes
Interface Port(s)
(1)USB serial control, (1) RS232 S20 port, (1) SmartSlot
Powerchute™ software supplied for many operating systems
DB9 dongle supplied for S20 port
Available
SmartSlot™ (for optional SNMP Ethernet
Network card PS9630) or environmental monitor card or multi I/O control card. (simple switching)
Windows ™XP and above will recognize this UPS when they are attached with USB. Windows™ PC will configure itself with its own drivers for graceful shutdown and UPS operation. Software also provided for UNIX, Linux.
Note, this RS232 S20 port is a new generation port and is not fully compatible
with previous generation software.
Control panel
LCD Written Word status display (alphanumeric) with predictive battery failure, Load and battery information Also the LCD can display the menus while programming the UPS.
The LCD can show:
•
Operating mode
•
Switched Outlet status, On or Off
•
Efficiency of the UPS
•
Information about the load
•
Battery capacity
•
Estimated runtime
•
Input and output voltage and frequency
•
Information about the last transfer to battery power
•
Self-test results
Configuration Configure the settings for the UPS:
•
Language
•
Local power quality: Good, Fair, Poor
•
Choose Standard or Advanced menus
•
LCD Display mode, Always On or Power-Saving
•
Audible alarms
•
Reset to Factory Defaults
Test & Diags Use the Test & Diags
menu to have the UPS perform a self test
If configured for Advanced Mode
Menu General Functions
Status View detailed information about the UPS:
•
Energy meter
•
Load current
•
Status of the Switched Outlet Group
•
Battery voltage
Configuration Configure advanced settings for the UPS:
•
Main and Switched Outlet Group—delays and settings
•
High and lower transfer points
•
Sensitivity settings
•
Date of last battery replacement
Control
Control the Main and Switched Outlet Group to turn on,
turn off, or reboot.
Test & Diags Perform a UPS alarm test or a runtime
calibration test.
Log View the event log for information about any changes to
the UPS and any faults.
About View information about the unit:
•
Hardware version
•
Software version
• NMC information (if applicable)
LED indicators On Line: On Battery: Replace Battery: and Overload/ Fault Indicators
Audible Alarm -Alarm when on battery: distinctive low battery alarm: configurable delays
Protection
Surge energy rating 459 Joules
Filtering- Full time multi-pole noise filtering: 0.3% IEEE surge let-through: zero clamping response time: meets UL 1449
Dimensions (PS1504 or PS1504i Tower)
Maximum Height 8.62 inches (219 mm)
Maximum Width 6.73 inches (171 mm)
Maximum Depth 17.28 inches (439mm)
Net Weight 53lbs. (24kg)
Shipping Weight 59 lbs. (27.5 kg)
Shipping Height 15.00 inches
Shipping Width 13.00 inches
Shipping Depth 24 inches
Color-
Gun Metal Black
Units per pallet=24
Operating Environment
32
- 104 °F (0 - 40 °C)
(battery dependant)
This can be -15°to +60°C
with our Premium battery
Operating Relative Humidity 0 - 95%
Operating Elevation 0-10000 feet (0-3000 meters)
Storage Temperature 5 - 113 °F (-15 - 45 °C)
Storage Relative Humidity 0 - 95%
Storage Elevation 0-50000 feet (0-15000 meters)
Audible noise at 1 meter from surface of unit 45.00 dBA
Online Thermal Dissipation-135 BTU /hr
2 year warranty on parts and Labor , 1 year on Batteries
RoHS 7b Exemption,REACH: Contains No SVHCs
cUL Listed,UL 1778
PS504iTower
C-tick,CE,EN 50091-1,EN 50091-2,VDE
Mounting
(option)
Powerstar builds mounting plates for hull or deck mounting. Padded steel plate with padded straps (hoops) wrap around UPS and hold it securely to the plate. The plate can be bolted or welded in place.
Option ; Stainless steel louvered upper case.
Also available with Master Bypass switch- connect the input power directly to outlets
We also build this model as a fully ruggedized MIL901D-A tested - PS1503ss